橡胶技术网

橡塑技术与装备
CHINA RUBBER/PLASTICS TECHNOLOGY & EQUIPMENT
2002 Vol.28 No.9 P.5-8

橡胶技术网

注模件的线性收缩偏差

Line contracting tolerance in molding parts (translated by)

David A.Velarde  Matthew J.Yeagley  刘作雄 

摘 要:所有注塑件都会发生收缩.本文将集中研究非结晶与半结晶塑料的收缩偏差,以及工艺效应、注模件壁厚效应和注流效应等收缩偏差.
关键词:注塑模件;注流效应;模件壁厚;收缩率;非结晶聚合物;结晶聚合物;纯净聚合物
分类号:TQ320.66  文献标识码:B

文章编号:1009-797X(2002)09-0005-04

参考文献:

[1]T. Whelan and J. Goff, Dynisco Injection Molder's Handbook,pp.173-83(1994).
[2]R.A. Malloy, plastic Part Design for Injection Molding-An Introduction, pp.63-84, SPE Publication#1202, Hanser Gardner Publications, Cincinnati(1994).
[3]J.P. Beaumont, "Shrinkage and Warpage analysis of Plastic Injection Molded Parts," SAE Technical Paper Series, 890626(1989).

收稿日期:2001年5月18日

出版日期:2002年9月1日

请看PDF全文